Puppy Hood - v1.0

Designed specially for trans men to remove clitoral access and reduce sensation. Printed using medical grade bioresin at 0.05mm, to ensure a smooth and body friendly finish.

The hood is similar in design to that found on the Puppy Clip - v2 and v2 Air, but is meant for those with genital piercings to provide the ultimate, minimal and permanent finish. The open design of the hood allows use of the bathroom and the hood also gives a small bulge in underwear. The standard size is for those with small to average bottom growth, while the large is for those with average to above average bottom growth.

The layout for the piercings is generic with 4mm holes each side, intended for horizontal bars and a single vertical opening at the top for those with a hood ring, bar or crescent. If you require a different configuration, please contact us using the 'Contact' page so we can create a custom version for your requirements (for an additional cost).

Please visit the 'Our Range' page for more details.